How to remove old asphalt shingles before putting on a new roof.
How to remove shingles from a steep roof.
Step 3 replacing rotten plywood.
Lever the split end of the hammer up to pull the nail out of the roof.
Gently tap a flat bar under the shingles to break the seal down strips free.
Ensure that as you.
Work your way down to the damaged shingles loosening adhesive and nails so.
In some cases you can.
If any nails will not come free drive them into the decking with your hammer.
You will want to start from one side of your roof and work your way to the other side.
In order to replace damaged roof shingles you need to remove the damaged shingle install the new one and seal the edges.
Remove leftover debris from the roof.
Remove all of the shingles on the roof.
Ways to work on a steeply pitched roof.
Removing asphalt shingles is a big job and you might be temped simply to lay the new roof over the old one.
Use the claw of a hammer to loosen the adhesive under the tabs 2 rows above the damaged shingles and then loosen any exposed nails with the claw.
Use the split end of a claw hammer to pry out nails still holding bits of shingles onto the roof.
Wedge the notch of the pry bar under the shingle at the nail head then pry up both shingle and nail.
The shingles will roll up like a ball in front of the fork.
A steep roof pitch can add to the cost of installation as it will be more time consuming to work on a steeper pitch.
The possibility of slipping and falling makes working on any roof dangerous but it s especially so if the roof rises more than 4 feet for every 12 feet of.
Remove the shingles in layers as you work your way up the roof.
Remove shingles in a 2 to 3 ft wide section as you work down the roof.
Use the shovel to pry the old shingles from the roof decking.
Step 2 removing the old shingles.
Nail on the new shingle nail down the new shingle propping the tabs.
Depending on the pitch additional equipment may also be necessary.
Continue tearing off the shingles and underlayment until you reach the roof jacks then start over at the top of the roof.
Check to be sure that the plywood that was under the shingles is still in good condition.
Don t force it shingles rip easily.
A complex roof architecture is more time consuming to complete than a simple flat roof due to angles and fitting.
Refrain from pulling out the.
Slide the split ends of the hammer under and around the nail.
